Cabinet Lock Installation

	Download the printable version of this page (pdf 1MB)
	Download the installation template (pdf 71KB)

Box Contents

Check that the contents of your box are correct according to the model:

Key	Part
1	Cabinet lock
2	Upper fixing bolt x 2
3	Packer pieces x 2
4	Locking nut
5	Cams x 2
6	Cam fixing bolt
	Batteries - 2 x 1.5V AAA
	Templates x 1
Tools Required
Tool
Power Drill
Drill bit: 6mm, 18mm
Phillips screwdriver
Adhesive tape, pencil, bradawl, tape measure
Pliers

Fitting Instructions

The Cabinet Lock can be fitted to:

• Cupboards, cabinets and lockers etc as a direct replacement for existing cam locks
• It can also be easily fitted to cupboards and cabinets that do not have an existing locking device

Special Notes

• Before installing the lock, load the batteries and familiarise yourself with the operation and programming
• The handle will not turn until you enter the factory default Master Code 11 33 55 77 OR the User Code 22 44
• Please see programming guide to set your own codes

Installation Guide

A) Replacing the existing cam lock with the Cabinet Lock:

	Download the printable version of this page (pdf 1MB)
	Download the installation template (pdf 71KB)

Step 1

Remove existing cam lock.

Step 2

Place template over hole left by cam lock and mark upper fixing hole.

Step 3

Drill the 6mm upper fixing hole.

Step 4

Fit the Cabinet Lock to the door by passing the spindle through the 16mm hole.

Step 5

If required, from the inside of the door, pass either of the packing pieces over the spindle to centralise the lock.

Step 6

Now secure the lock by threading the large nut onto the spindle.

Step 7

Fit one of the upper fixing bolts to suit your door thickness.

Step 8

Tighten the lower fixing nut and upper bolt.

Step 9

Select the cam which suits your door and frame and attach it to the square shaft at the end of the spindle.

Step 10

Now check the operation of the lock using the factory User Code 22 44.

Step 11

If the lock is functioning correctly, CHANGE THE DEFAULT MASTER CODE 11 33 55 77 and DEFAULT USER CODE 22 44 and program the lock using the programming and operating instructions enclosed

B) New Installation:

Step 1

Place template on door and mark upper 6mm hole and lower 16mm hole.

Important note: Before drilling fixing holes, please ensure that the position of the cabinet lock when fitted will allow enough clearance for selected cam to work.

Step 2

Drill both fixing holes.

Step 3

Continue installation from step 4 to 11, above.

	Download the printable version of this page (pdf 1MB)
	Download the installation template (pdf 71KB)

• If help is needed before, during or after installation call our freephone helpline 0800 393 405.