Back to back front and back plates for use with existing mortice latch or lock.
The existing lock must have either a fixing hole 22mm below follower (spindle) or two horizontal holes either side of the follower (38mm centres).
Quick Code change!
The CL600 range incorporates the new Quick Code system which allows on door code change in seconds. Typically most mechanical digital locks require the lock to be removed from the door or partly disassembled to change the code.
The CL600BB coded plates are supplied with a random code commencing with the ‘C’ clear button. The code is non sequential, that is the code can be entered in any order e.g. 1234 can be 4321 or 1342 or whatever is the most convenient sequence. With the 13 buttons a total of 8,191 different codes are available, any of which may be entered in any order.
IMPORTANT: When using CL600BB front and back plates, please test with your selected lock-case to ensure that the latch retracts fully from the code side without too much resistance. Some lock-cases have a heavily sprung latch follower designed to use with un-sprung lever furniture. This heavy springing can defeat the clutch on our locks. If in doubt do not specify one of our locks with a lock-case that is designed for use with un-sprung lever furniture. Please note the code chamber for mechanical locks requires the lever to be rotated at least 45 degrees to re-set the lock the for next code user. Please contact our Codelocks technical department if you are unsure. Codelocks Limited does not accept responsibility for products incorrectly specified.
* CL600 does not require a separate installation template. Please use the neoprene seal that comes with the product. Download instructions opposite for full installation guide.
Brand: CodelocksBody Material: Zinc AlloyCodes: 8,191 non sequential codes availableCode change method: On door via keyCode in / code out: YesCode storage: Single codeDoor thickness: 35mm - 60mm (1 3/8" - 2 3/8")Keying alike: Locks can be keyed alike on requestKey cylinder change: From lock front (6 pin)Key override: As standard the lock has a key override functionNon handed: Lock will fit doors hung on the left or rightSpindle type: 2 part 8mm (5/16") spring loaded spindleSuitable for: Internal and external useType: Front & backplates only
(Details shown apply to the default selection)
Spare parts are available to order online. From fixing bolts to replacement latches, we've got it covered.
Access the product card here
CL600 Tech Spec sheet download
Be the first to Write a Review for this item!
0 Items - £0.00 | View Basket
+44 (0)1635 239 645
Copyright © 2018. All Rights Reserved.
Home > Mechanical Locks > CL600