Codelock 500 Installation

Download the printable version of this page (pdf 935KB)

Box Contents

Check that the contents of your box are correct according to the model:

Key	Part	Model
		500/505	510/515	520/525
1	Front plate and handle
2	Back plate and handle
3	Neoprene seals x2
4 a)	RED & BLUE tipped spindles
4 b)	Butterfly spindle
5	Fixing bolts x2 (1x spare)
6	Spare code tumblers x2
7	Tweezers for code changing
8	Allen keys x2
9	Euro profile cylinder escutcheons	1 pair	-	1 pair
9a	Keyhole escutcheons	1 pair	-	-
10	Mortice latch, strike & 4 screws	-		-
11	2 bolt mortice lock and strike	-	-
12	Double Euro-profile cylinder & 3 keys	-	-
13	Adaptor kit for mortice locks with horizontal fixings		-	-
14	Latch support post	-		-
-	Installation template	-	Download	Download
-	Code change instructions
-	Code card
Tools Required
Tool		410/415	510/515	420/425
Power Drill
Drill bit: 30mm		-	-
25mm		-		-
20mm		-	-
16mm		-	-
12mm
Phillips screwdriver
Chisel 22mm		-	-
Chisel 25mm		-
Hammer/mallet		-
Stanley knife		-
Adhesive tape, penicl, bradawl, tape measure		-

Installation Instructions

• Model 500/505 Installation Instructions
• Model 510/515 Installation Instructions
• Model 520/525 Installation Instructions

Check operation of the coded front plate

On models 505, 515 and 525 note the slotted turn within the bottom left hand button. If the slot is in the vertical position it signifies that a code is needed each time to operate the lever handle.

Enter the code from the code card and the lever handle should turn fully to 80 degrees, and then spring back to horizontal. Enter the code again, turn the slot to the horizontal position and the lock will be in code-free access mode. Return the slot to the vertical position and after one further free turn the lock will be in code control mode again.

Turn the front plate over and note that the red tipped tumblers inside correspond to the code. The code may be entered in any sequence, i.e. 1370 may be entered as 3710 or any other sequence of those numbers. There are a total of 2047 codes available on the 500, 510 and 520 locks, any of which may be entered in any order.

There are 1023 codes available on the 505, 515 and 525. If you intend to change the code you should do it, if convenient, before installing the lock – see the Code Change Instructions in the separate sheet.

Download the printable version of this page (pdf 935KB)

• If help is needed before, during or after installation call our freephone helpline 0800 393 405.